5 Amazing Tips To Prevent Clogged Sewer Lines
Plumbing problems can occur at any point of time. And, no matter big or small, they end up disturbing your entire routine and make you annoyed. Most of the time it is difficult to deal with them on your own, and a professional plumber is required for the same.
While, a leaky tap is
still tolerable, but if it’s something worse like a clogged toilet or sewer
line, you know you’re in huge trouble. The water flowing all over the floor,
mess all around, and you’re sitting there clueless with your head in your
hands!
Well, do not worry! You
can handle all that by calling an expert for sewer pipe repair and you
can easily find them online too.
To prevent such a
disaster from taking place, you can follow these tips to save the sewer lines
from being clogged.
#1. Don’t put FOG in it
FOG - fats, oils, and
grease are the worst enemies of sewer lines. When you wash dishes or perform
other tasks, the FOG that goes down the drain forms huge and thick grease balls
that block the pipes.
Sewer backups and spills
can be a result of clogged pipes, and they create environmental problems,
traffic tie-ups, or even flooded homes and businesses. Plus, it is going to
cost you a lot for its cleanup.
#2. Don’t Flush Hygiene
Products and Wipes Down the Toilet
Though it’s obvious that
the only thing that should go down the toilet is human waste and toilet paper,
many people also throw sanitary napkins, wipes, and other hygiene products.
Do NOT flush anything
that would clog the sewer pipe. You are creating trouble for yourself by doing
that, and cleaning it can be far more expensive than you can even think
of.
#3. Replace Old Pipes
One of the reasons for
clogged sewer lines can be old pipes. If you have been in the same place for a
very long time, and haven’t got a check for your plumbing system, then you
should consider getting maintenance done.
Pipes tend to corrode
over several years, and older homes with clay or lead pipes can create severe
blockages. So, get sewer line replacement as this is much easier than dealing
with a serious clog.
#4. Don't Rinse Cement,
or other Construction Material Down the Drain
Setting-type joint
compound hardens by a chemical reaction and will set up even under water, so if
it settles in your drain you're in for a rock-hard clog. Sand is another
building product that is notoriously bad for drains. Sand is heavy and settles
quickly in traps and pipes to form clogs that are difficult to remove.
To avoid these problems,
never rinse setting compound, grout, mortar mix or concrete down the drain.
Instead, save rinse water in a container until the solid materials settle out.
#5. Get in Touch With a
Professional
Never wait for plumbing
problems to get worse. Even if it seems a minor issue to you, it might be big
in the plumbing world, and should be dealt with immediately.
And, the moment you feel
the water isn’t flowing freely through the pipes, consider calling an
experienced plumber, Chicago, or from another place instantly. They can
fix the issue better than your DIY tips, and will offer you a long-term
solution.
Conclusion
Comments
Post a Comment